Search results

for sale is an OPS 45 that has destroyed itself, probably only good for parts the undamaged parts are collet flywheel crank (as far as i can tell its ok) front plate/ bearing housing wrist pin back plate carby water jacket exhaust header and water cooled flange and all the screws im...

just wondering if anyone else has used micro servos for the throttle and what their experience was i have gone through 4 different ones on my 45 rigger, they just keep dieing, they only last about 2 days of running and just stop moving and never work again, have also tried rubber mounting them...

im after a header, spring, and seal for an old cmb 45 20mm inlet and outlet, 10 or 12 degree bend would prefer a cheap used one

just wondering if you guys have much luck building tuned pipes yourself i made one for a gas engine from .6mm steel sheet hand rolled, i was a pita to make and it kept cracking from the vibration :angry: is there an easier way to do it?

hi, let me start off by saying this is my first nitro boat and also first rigger so i really don't know what im doing its a JAE-45 rigger, most of the time it stalls within 20 feet and sometimes it will do 2 laps but only just up on plane and seeming like it is only at like 1/4 throttle when i...

Just building my first rigger, wondering if i need to lay some fiberglass down in the engine bay area, btw its a .45

have here a gas rigger built from firefighter plans, no cowl or boom tubes but setup to run 5/8" main tubes, 5" inside tub width, bare wood boat that hasn't even been sealed yet $280 plus shipping, i am located in Australia and am not sure how much shipping will be

hi, just wondering what sort of speed could be expected from a .45 rigger in race trim, also curious what others size boats are doing too