Recent content by YOGI

THANK YOU I WILL GIVE HIM A TRY

I'M RUNNING THE ADJUSTABLE MOTOR MOUNT LOOKS TO BE DUBRO OR OCTURA NOT SURE WHICH. I'LL PROBABLY STICK WITH IT FOR NOW. I JUST PURCHASED A BULLET DRIVE LOWER END AND NOW I'M RESEARCHING PIPES. ANY SUGGESTIONS? THE SILVER BULLET PIPE SOUNDS LIKE THE ONE. LOOKS LIKE I WILL HAVE TO MAKE A HEADER...

THANK YOU VERY MUCH FOR THE INFO. I ORDERED A HI TECH 1/4 SCALE SERVO. THIS IS AN OLD HULL THAT I'M RESTORING. I RAN IT 1 DAY AND QUICKLY REALISED THAT THE STEERING NEEDED TO BE TIGHTENED UP. WHEN YOU GET ON THE PIPE IT WOULD NOT STEER AND WOULD DART LEFT OR RIGHT. I'M ASSUMING THAT IT WAS THE...

I AM TRYING TO FIND OUT A GOOD STARTING POINT FOR THE ADJUSTABLE MOTOR MOUNT MOUNTING TO TRANSOM. WHERE SHOULD THE PROP LINE BE IN RELATION TO THE BOTTOM OF THE TUNNELL? ALSO WHAT IS A GOOD LINKAGE TO USE FOR THE STEERING? I DON'T LIKE THE SLOP IN THE CABLES.

I DID LIGHTEN THE FRAMEWORK AND DID REPLACE MOST OF THE ORIGINAL PLYWOOD WITH BIRCH PLYWOOD I DID NOT WIDEN THE TUNNELL I HAD ALREADY STARTED ASSEMBLY WHEN I READ ABOUT SOME OF THE MODS. I DID SHORTEN THE REAR SECTION OF THE COWLING TO ACOMMODATE THE PIPE. THANK YOU FOR YOUR REPLY I WILL TRY...

THANK YOU, IF I HAD IT TO DO OVER AGAIN I THINK I WOULD HAVE WENT ANOTHER DIRECTION OH WELL!!

I AM BUILDING A DUMAS 36" ATLAS VAN LINES HYDRO. I WAS WONDERING IF ANYONE OUT THERE HAS BUILT ONE ? ALSO PIPE LENTH FROM PLUG TO BRAISE LINE, MAC .45 WITH A MACS TUNED PIPE. ALSO ANY PROP SUGGESTIONS.