A production of 100Pcs has been made in September 2015
It took some time but all has been sold. Since then I have tried to convince OS to make me a new batch based upon the R21 engines but we have run out of discussion because simply too expensive for the small numbers possible to sell.
We still...
If you look at the tolerances(outside and inside diameter) given by bearing manufacturers, you will notice that they are quite big compared to the tolerances used rectifying the crankshaft itself.
So in a production it is very hard to get the perfect fit and even more difficult to assure the...
Hello Ricky, first of all good luck with this venture. We do not know each other but I have some very old connection with the Metkemijer brothers and we all share the same passion.
I have read this post with interest and would like to share with you some of my findings and let you guess the...
Hi,
Always good to be able to adjust your engine while you are running.
For where to put and where to buy check the following topic for this: https://www.intlwaters.com/index.php?/topic/75748-remote-valve-setup/
Hi Bob,
Yes, that is an .21 outboard engine.
Only for .21 size engines there is a wide range of homologated pipes available. Unfortunately not for the .45 size engines.
For whom is interested I still have some of these available:
http://www.worldchampionproducts.com/en/tp01001-21xm7/378-crankshaft-21-ob14-168-35-245-cwr.html
OS has raised their pricing probably due to not enough production.
The deals you can find are of previous productions so take profit of this while you can...:-)