Recent content by ricwally

Steve, I will take the kit if Shane decides to pass.

Bob, I would like a 1715 and a 1717.

PM sent with address. Thanks

Alan, pictures show two 2219-19-38 props. The listing shows a 2218-19-38. I would like either a 2218 or a 2219 whichever is correct. Or I will take a 2218 and a 2219 if both are available.

John, is boat stand included? Can you post a picture of inside radio box? What is motor mount drilled for? Thanks you sir.

If it is a snug fit. I don’t know why Loctite 648 wouldn’t work. It is used to hold the prop shaft on a wire drive In some applications. I would think that there would be much more stress on a prop shaft vs a pushrod. It would probably have two or three times more surface area to adhere to with...

.004

That motor is a Novarossi 12 Plus SCT 3.

Zippkits .12 Rigger play day. It had been hanging on the wall for over two years. 83mph run in heat racing trim on this tank of fuel. Three or four different runs with speeds of 79 to 83 mph. We left a little on the table LOL! These little boats are always a blast!

There is no Summerville, NC!

I ran CB carbs exclusively back in the mid to late 80s. low to mid-range fuel flow isn't the best. They work okay. Better suited for SAW.

For heat racing the Geraghty is better.

Looks more like a Geraghty carb to me.

Money sent with additional $15 included to cover shipping. I will PM you my shipping address. Thanks.

Bill, I will take it if Al passes on it. Thanks