I have been using an MT-4 with telemetry for RC boat racing for years.
I recently acquired a TLS-01 data logger. I also managed to find the SD-U01 interface cable/hardware but I need the PC Manager software to load the data onto the PC and the download link on the Sanwa product page no longer...
I've been using the Voodoo Black Magic pitch gauge for a few years.
I like it because it is a continuous measurement system using a digital dial indicator. It's also pretty easy to measure at different places on the blade!,
JMHO
Picked up a Sanwa TLS-01 Telemetry Logger System.
There is an optional PC interface transfer cable (SD-U01) and associated PC Management software.
Does anyone have a reference for the cable or a link to the PC software?
The leads on the temperature sensors for the HiTec Proton 4 are pretty short and I need to extend them.
Would it be better to cut and solder wire of the same gauge or build extension cables (but I can't find a matching connector)?
The HiTec connector seems to be the same connector as on my Sanwa...
I am going to include telemetry on my gas Slingshot build. I started with nitro in the 90's, and settled on FE hydros and riggers for quite a number of years (still active).
This will be my first gas boat.
I have a receiver with one port for temperature...should I monitor cylinder head or...
I found a HiTech Lynx 4S radio NIB. The Proton 4 receivers are still available even on Amazon. The Proton 4 is a telemetry receiver with on-board GPS, and plug-in sensors for temperature, rpm plus full-time receiver voltage monitoring.
It even has a micro SD card slot and earphone jack if you...
I'm putting together a Blazer Slingshot this winter and this is my first gas boat.
I like ABC/2 cleavers on my FE riggers.
Any recomendations to break in a mild small-block and then what to use for heat raving?