Recent content by justaddwata

Sorry for the confusion - They were the original "no ring" version that were run first. The ringed versions have since been fitted.

Most every prop I have is snug or better. Occasionally I have to ream one out to fit. Then again not all shafts are the same. I find the German stern drives and European cables tend to be a tighter fit overall. Is the shaft measuring .250 exact?

Have a pair of CMB35s that did a few short runs with no rings without issue. I know the instructions were pretty explicit about what size water fitting to use etc and remember hearing of a few seizures at the time. CMB sent through new ringed pistons to retrofit it. Have only bench run since.

Arrow shark have mounted servos to their 30 and 60 motors. I was curious how they might hold up. Good to see - linkages are pretty complex on some boats. X30-Advance Version_X-30 Marine_Gas Engines_Arrow Shark RC Marine

Have just heard back recently from BZM regarding my concerns over possible reed issue. While looking the motor over I spotted chips missing from one of the reeds. This is an unfired, unfueled motor. BZM techs assure me there should be no problem running them ("Our technicians, after carefully...

Any pics of Pipe offered for them? Also - Believe I have a 28cc - is there an easy way to identify what size motor I have (a stamping etc)

No problem Mike. (I am sorry to cry about it). I am more sorry to not have the $$ on hand now :rolleyes:

About a year ago you were selling her Mike. I made you an offer (higher than current price) and you never responded to my e-mails. I was pretty disappointed to never get a response :blink: