Jeff Lutz's latest activity

Twin class was created so it would be its own class. After it was an official class, I myself asked Mark Bullard who was very involved...

Mark, Mike will sell to gas guys but it may cost more. Lol

Mike, the 6201 is the new PTO side bearing on the .91/.101 Mline series CMB big blocks. It’s still a 6001 on the carb side. SKF part...

On the .46 that’s how it is, but the bearing fits and all inside is machined dead nuts. No problems there.

Now I know why you wear that Ford hat…

Hey Al, no doubt the WIB bearings are fantastic also. Jim Allen had a lot of education from Henry Nelson. He bought a large quantity of...

I haven’t seen anyone mention flexing. Me and a few others have talked about the bearing getting out of round. The 90/101 Evo’s in the...

The main reason for the big bearing failures in Vac .91’s is the case fit that it goes in. The upper half of the bearing is only held by...

Oh yea, I knew you were referring to boat only. I just expanded that into the full combo and it’s probably more like $1,300 for a Jae...

I saw a ad with you looking for Crapshooters for your boys. Surely you didn’t tell them they could get one for $350 shipped, possibly...

Als engine is $385 but you have to buy a carb, make it $485 plus the $100 kit plus shipping. Still need a header,pipe,collet,prop,flex...

Sure, I knew you mistyped. Haha ..I tested aluminum versus brass years ago on CMB 100 engines. It’s not as drastic of a change as you...

Hmmm. No, I say that would be about the same. Lol

Man that’s cheap. Should be sold.

I would point out to people that you added a center rear sponson (ski type) to this boat which changes the setup from Andy Browns...