Ya it stayed on just fine.
Was considering a couple of pins to line it up. But rush rush! I may Tig on a couple later.
I did t-bone the dock no damage! :blink: and it just slid forward a inch.
Now to build a windscreen!
Got her wet and ran approx 1/2 gal threw the green head.
Ran respectable ;) Hope to get some tuning in next weekend.
Looking forward to race her at the Northern Nats
Eh John that one is a Rainer merlin I ordered from http://www.hallammarinehobby.com/index.html
At the pond today first time since last year! Seems I had dirt in the violet needle.
so she farted around! Then I snapped the starter belt and went home :angry: :angry:
Thanks great link jwo! they got a large selection of counter sunk magnets.
Noticed you can get them in south or north facing out. Getting a N/S stuck together :lol: good luck removing a dummy engine :blink:
Now I'm wondering how to mount the Driver Cowl section??
Got a plan for the rear...
Changed it up a little by extending the size! Using 6 magnets and it works great.
Can almost lift the boat up! There real strong.
Good news is dummy floats.
Here is the 4130 rails installed on the dummy
Ever ting will get powder coated
I got these ones from Mike Hallam http://www.hallammarinehobby.com/
He was using them on his scale.
Or you should find them here!
http://www.mcmaster.com/#
opps just noticed your a Canadian and Mcmaster will only ship to existing dealers here in Canada some kinda bull S
Ya we used Endura clear 100 Approx mix ratio was 50/50 with 15% thinner. So figure it was a poor mix. Also hull was hanging by the stern.
Anyway that will be a project for the winter.
Here's how I plan to mount the dummy engine. Any Better Ideas are welcome :unsure: