yes, if you go to a graphics type busIness, they should be able to print or plot those files to full size (or actual size). So when you place drawing on flat surface the hull length should measure approx 35”
Time permitting, I can/will eventually cutout and trim original wood parts (bulkheads...
these are exactly what the plans looks like. Both are PDF format. I also have JPEG versions as well, but still need to access files on my drive storage
The detail drawing is full size, however only shows top and side views. Bulkheads would require tracing actual parts. Otherwise most parts can...
I have them, just need a few days to get access. I moved a while back and everything’s in disarray.
You definitely want to go with an SK60, and not an SK40. SK40 too short (I’d run .21 in the SK40).
exactly how I would set it up! It will run good, even on oval.
I set the forward edge of the center keel at the CG point of the hull (approx 33% location, from transom).
Hello:
For sale is an original vintage OPS .45 Marine engine. This was the second of two engines I purchased brand new from Shamrock imports back around 1986. Both engines were originally blueprinted by Steve O'Donnell himself. No modifications were done, only clean and re-build.
It has RPM...