Recent content by Craig Hollingshead

Is this the correct one? 2L Belt Type X 1/4 Inch X 20 Inch Outside Diameter. The 19 inch one I have in Speedmaster seems to be an OK length.

Done that already...thx

I am using a Speedmaster belt. I got 4.8Ah into the battery after a full discharge. I am doing another discharge/charge cycle

New belt and it does fit correctly. I think my battery is not up to snuff. Trying the discharge/charge

It is a new battery. I will try a full discharge and then charge it back up again. It is not locking up.

Good day: I picked up a electric belt starter, a new TFL Hobby. I am using a 19 inch belt, a 5000mAh, 100c, 4S, 14.8 battery. My engine is a Zenoah G300 marine with approximately 10 hours on it, so it is not new. The battery has a full charge. The starter will not spin the engine over more...

I tried to look him up with no success. Any ideas?

Merry Christmas to one and all!

It will spin at 10000 rpm...not fast enough?

Thanks for your replies...still pondering the choice of the 180.

So, I think I will build a outrigger with my Saito 180. Any ideas as to how to fit a drive line? Need a flywheel, and collet. Will probably go with a wire drive. Any thoughts would be appreciated. Craig

What would be a good boat for my Saito 180?

I have a Saito 180 I was thinking of putting into a boat. Too big??

Good, cuz that is where I put it…lol. Thanks.

Does it matter if the starter pulley is on the front or rear of a Zenoah engine? Craig