Recent content by ace

Are you adjusting the turn fin after setting the ride height an sponson angle,did the turn fin bend when you crashed it ,check that

Hi Shane what is the wieght of the boat as is ?may be interested regards Ace

Kevin received mine today, very impressive tool indeed , Cheers Ace

I have run Barr cut with a twin but only with COCR props an still yet to tear a blade touch wood ,the improvement for me was higher speed from being able to add more pitch cup and better throttle response but that was barr cutting both props ,I have run smaller diameter on inside engine but no...

Hi Jeff,I didnt mention any thing about losing blades but I will ,Julian mentioned Vcuts on 2821`s to me I would be very wary of doing that there is not a great deal of meat on them props and with hop they will tear quite easy ,Again I didn't say any thing about 1667`s they are a good all round...

Be careful they will tear a blade off, especially with hop .12"inch pipe is long ,I was running @10.5 with a 2819 an only running CMB 90`s ,,will pull 2170`s doing 99mph haven't been near that with the game changers ,an no problems finding the set up for that ,i just think the game changers are...

David my boat is fine without those props , done all that you have said , am playing with different props , I run out of ideas for making those props work cant say i tried , i have wasted alot of time an gone backwards with boat handling not speed . but give it time I will stew it over in my...

Charlie your boat is hopping like mad your losing so much drive,an backing off for the turn is old school of thought,,I can keep it full throttle at all times even for slight left turns,you have to remember Charlie we have different boats an as if I would just guess what set up I run I am a bit...

The Negative strut angle with those props caused me to lose a Nationals, in the turns it caused the boat to drive its nose in an lift the ass so bad the boat spun on a couple of occassions i was leading at both times , i have experimented alot with these props an they do not impress me at all...

This Sport really needs this ,we need to promote model boating ,more people coming to the sport,awesome effort Jeff. Perhaps you would like to come to Australia an do a report on the Australian Nationals in three weeks , come an see am report on some Aussie Racing we need the Promoting to...

to me HP at high rpm means nothing we cant use it we need HP at low rpm to pull bigger props , pity we cant change gear

Charlie I have the same set up as the photo but have rounded the struts on the bottom , I had problems with the struts coming loose but just added another bolt to clamp the struts from coming loose I would suggest the same for the boat in the photo another thing I would do is plate the back of...

Charlie, I did as you have done on my single 90 to the strut and sponsons and was wondering how far I would have to go on my twin , I do run round struts and do have a set of flats but to me a bit more angle wont hurt as easier to take hop out with less angle than with flat struts , when i tried...

Thanks Brian I have done similar to what you have done but not sure my 90`s will pull them ,I did not get to try them this weekend as I was at my sisters farm helping out for a bushfire that was heading their way , thankfully the wind changed direction ,so hopefully this weekend I`ll get to try...

good luck Tom , we have them here to and bloody big carp , I have an open mind David I`ll be going to a different part of the world racing a different format and totally unusual conditions an competition, ,but will give it a bloody good go ,I`m used to being throw in the deep end operating...