- Joined
- Nov 25, 2003
- Messages
- 16,377
Hate to do it but I need to continue cutting back on some projects so I'm selling my R/C Boat Company SG118H hull. It has the optional carbon reinforcements Steve does and I will give whoever buys it their choice of cowl sets, either the 8806 Madison/Kelloggs/Oberto/Jasper or the 8701 Bud set. The 8806 cowl has been trial fitted, the 8701 is still untrimmed and final fitment and glassing/blending will need to be done on either one. Both boats used the full length turbine tube so of course that goes with either choice. The rear extensions (in plastic bag in parts pic) will be included with the 8701 cowl set. The tub area has been opened up, right side tank pocket removed and both sides sheeted with G-10 then lined with carbon veil. The new custom stepped front area forward of the motor is 6.5" long and 3.75" wide, fuel tank height would be 1.5" front, 2" rear which should yield approx. a 23oz. capacity. The transom is already drilled for the rudder bracket, the hull was new but had been set up with an extended strut/stuffing tube when I received it and those were filled in as I prefer standard strut closer to the transom. Motor mount holes are drilled from the underside but need to be popped thru the newly applied carbon veil. As pics show carbon fiber rear wing set, New Speedmaster 1/4" hydro strut kit, Accutech offset motor mount, turn fin w/ bracket, rudder assembly are included. Side mount radio box and salt water scoop extension too. The front canards were removed to do front end mods and fitment of cowling but they are there for reinstall when cowl area is completed. New windshield for either cowl will be included as well as the cockpit liner. This is a really nice hull and I was looking forward to building it, I'd like to see it get a good home. $650 plus packing, shipping and insurance, this is normally well over $800 to buy without the extra work.
Last edited by a moderator:
