Picco 90 Marine RPM Rods & Stock Rods

[edwardabele]

jim i do want them ,need a price shipped

thank you ed

 

[jim kapanowski]

RPM ROD $ 40.00

steel rod $ 20.00

i have one RPM and two steel

shipped

 

[edwardabele]

JIM I WANT THE RPM ROD AND 1 STEEL ROD ,, I AM NEW TO I/W SO I AM UNSURE HOW TO DO THIS ,,I DO ALOT OF TRANSACTIONS ON OTHER SITES HOWEVER ,, I CAN DO IT VIA PAYPAL OR CAN SEND MONEY ORDER OR WHATEVER YOU WANT ,THESE ARE A BIG HELP

THANK YOU ED

 

[jim kapanowski]

send to paypal address [email protected] I would like to sell all three rods if possible how bought $ 70 sent as a gift for the hole lot shipped

 

[edwardabele]

JIM I WILL TAKE ALL 3 FOR $70 ,,I WILL SEND YOU THE MONEY LATE TONIGHT OR TOMMORROW AFTER WORK ,, THANK YOU VERY MUCH ,, YOU WERE VERY HELPFUL ,,

ED

 

[edwardabele]

JIM I SENT THE MONEY TO YOU ,, I HAD TO SEND A CARD WITH MONEY IT TOLD ME SO I JUST LET IT PICK IT ,, THANK YOU VERY MUH AND WHEN I RECEIVE THEM I CAN HAVE MY 2 MOTORS REBILT ,, THANK YOU MUCH THESE ARE HUGE HELP ,,

ED

 

[brad nichols]

Ed I got ahold of my motor guy and he got all the parts sorted out and with the crank cases I have he would only have a rod left over. I take by your last post you may of found enough parts for yours I hope. That engine from Joe is a good deal.

Brad

 

[edwardabele]

BRAD THANK YOU ,, I BOUGHT 3 RODS FROM JIM HOWEVER IS YOUR ROD A RPM ROD OR STEEL ,, IF RPM AND WANT TO SELL I WILL BUY ,,I HAVE TWO MTORS TO REBUILD ,, I ALSO WANT TO BUY THAT MOTOR FROM JOE IS HE WILL SELL TO ME IN A WEEK OR TWO ,,I LOVE P-90S ,, I JUST SPENT A TON ,2 PISTONS /SLEEVES ,1 CRANK,ECT ,, ,AND THESES RODS ,, AND WERE DO YOU GUYS GET YOUR MOTORS BUILT AT,,I USED TO USE A GUY NAMED RON G BUT HE SHUT HIS SHOP DOWN 5 YEARS AGO ,, I NEED A NEW BUILDER ,, I THANK EVERYONE WHO HAS HELPED ME ,, I WILL BE LISTING ALOT OF OLDER RC BOAT STUFF ONCE I AM ALLOWED TO ,,I AM NEW TO I/W SO NEED TO GET 30 POSTS BUT HOPEULLY I CAN REPAY ALL YOU ALL FOR HELP

THANK YOU VERY MUCH ;;; ED

 

[edwardabele]

BRAD I SAID WRONG BUILDER IT WAS NOT RON G IT WAS ROD G. THANK YOU ED

 

[brad nichols]

It was a steel rod. My guy is in Calgary and I build boats for him and he does motors for me.

Brad

 

[edwardabele]

OK THANK YOU ANYWAY ,,THANK YOU FOR YOUR HELP

ED

 

[edwardabele]

Jim rods came today ,, Thank you ,, I am still looking for more Picco 90 marine engine parts with bolt on header if any out there

Thank You

ED

 

[PaulHail]

I have a complete Picco 90 engine that I purchased used but haven't run. I did replace the stock rod with a new RPM rod. The engine appears to be stock, has good pinch and the bearings seem to be in good shape.

Make me an offer.