happybradboating
Well-Known Member
- Joined
- Jul 3, 2007
- Messages
- 1,083
The first #3 Picco 90 Hydro motor is complete and in good condition. It has the standard stock Picco roller bearing and rod. The Piston/Sleeve is in good condition with a strong pinch at TDC. When looking over the backing plate it may be noticed that the carb is held together by 440 bolts & epoxy. This makes it permanently locked into place.
The head shim thicknesses are as follows: 2Qt .004's & 1Qt .003.
Please reply to this post. The reduced price for #3 motor is now a [SIZE=12pt]Price Drop at $80.00[/SIZE].
The second #4 Picco 90 Hydro motor can be used for parts. It has a engine case that has been welded after it had a rod punch a hole in the casing. I think it may be leaking but not sure. It includes a used Picco Piston/Sleeve that is in average condition. The backing plates & carb is held together by 440 bolts & epoxy. This motor case has had the head bolts stripped out in the past and it looks like someone has tapped out the engine case to larger 6/32 bolts.
The head shim thicknesses are as follows: 2Qt .004's & 1Qt .003.
The price for #3 motor is now a [SIZE=12pt]Price Drop at $50.00[/SIZE]. The piston/sleeve and RPM rod are in good shape, especially the RPM rod.
On a side note! I currently have the #4 Piston & Cylinder installed into the #3 motor case and related #3 parts. This was done so I could determine the condition of the #4 engine case. It appears that the #4 engine case is no good, as best I can tell.
If someone wants both Picco #3 & #4 the combined cost will be a [SIZE=12pt]Price Drop at $130.00[/SIZE] plus shipping.
In summary, shipping will need to be calculated into the price for the motor(s) & parts listed. If my Paypal information is requested send inquiry by PM. Will accept USPS money orders. Please reply to this post.
The head shim thicknesses are as follows: 2Qt .004's & 1Qt .003.
Please reply to this post. The reduced price for #3 motor is now a [SIZE=12pt]Price Drop at $80.00[/SIZE].
The second #4 Picco 90 Hydro motor can be used for parts. It has a engine case that has been welded after it had a rod punch a hole in the casing. I think it may be leaking but not sure. It includes a used Picco Piston/Sleeve that is in average condition. The backing plates & carb is held together by 440 bolts & epoxy. This motor case has had the head bolts stripped out in the past and it looks like someone has tapped out the engine case to larger 6/32 bolts.
The head shim thicknesses are as follows: 2Qt .004's & 1Qt .003.
The price for #3 motor is now a [SIZE=12pt]Price Drop at $50.00[/SIZE]. The piston/sleeve and RPM rod are in good shape, especially the RPM rod.
On a side note! I currently have the #4 Piston & Cylinder installed into the #3 motor case and related #3 parts. This was done so I could determine the condition of the #4 engine case. It appears that the #4 engine case is no good, as best I can tell.
If someone wants both Picco #3 & #4 the combined cost will be a [SIZE=12pt]Price Drop at $130.00[/SIZE] plus shipping.
In summary, shipping will need to be calculated into the price for the motor(s) & parts listed. If my Paypal information is requested send inquiry by PM. Will accept USPS money orders. Please reply to this post.
Last edited by a moderator:
