Ops exhaust manifold

[Michael Villeneuve]

Hey guys I'm either looking for a way to do it or looking for to buy one.
Basically this OPS .67 (or .60?) header has a slight angle to it but I need it to be straight.
Any ways I could make it straight?
Or where I can get a straight one?

Thanks alot

 

[brad nichols]

I made one for another boater here for a scale boat

Brad

 

[brad nichols]

Do need one let me know as I can make another. PM on here

Brad

 

[Jim Allen]

I have machined many types & different angles of steel exhaust headers for OPS type rear exhaust engines. The fixtures pictured allowed me to select any possible angle. Notice the pressure fitting location. No gasket of any type is ever used in nitro or gas engine headers. Headers made this way eliminate the usual straight section found inside standard tuned pipes used on nitro & gas engines!

Jim Allen

 

[Patrick Au]

Michael, i have two OPS 80 straight exhaust adpators but the distance of bolting holes are slightly wider than 60/67. If you can modify to suit your 67 engine that i will sell you at reasonable cost.