K&B 67 Straight header

[WikiWiki1]

Anyone know where I can get a straight (not angled) header for a K&B 67? I'm fitting one into

my scale hydro and the angled one won't work with my cowling.

Thanks, Brent

 

[tnrcboatracer]

let me check, I may have one.

 

[FloridaScaleBoater]

I think Mac's exhaust makes one

 

[Mike Hughes]

Here is a link.

http://www.macspro.com/headers_rear.asp

 

[rctinman]

If you know someone with a lathe, they can take a pass across the face and make it straight.

Steve

 

[tnrcboatracer]

If you know someone with a lathe, they can take a pass across the face and make it straight.
Steve

That's what I planned to do. I have one for you. It is new. How about $20 shipped to you

 

[WikiWiki1]

If you know someone with a lathe, they can take a pass across the face and make it straight.
Steve

I was considering doing this however I think if you cut it down the there won't be much meat left for the bolt heads and they may pull through. The bolt head surfaces would also be at an angle.

Brent

 

[Joe Wiebelhaus]

Brent, I have 2 new MAC 67 fuse top headers for K&B 67 engines, they are straight, but bent with a curve to get over a rear radio box.

jw

 

[WikiWiki1]

Brent, I have 2 new MAC 67 fuse top headers for K&B 67 engines, they are straight, but bent with a curve to get over a rear radio box.jw

Thanks Joe but I ordered one last week.

Brent