Jack Brady
Active Member
- Joined
- Jun 11, 2009
- Messages
- 41
Hello,I am running a Woodstuff hull,electric 4 cell. It ran fine before so I think I need to undo some work I did to the hull. I wetsanded with a block the hull bottom. It was pretty thick with clearcoat so I was able to get nice sharp edges, The problem I have now is when I set it into the turn it hooks real easy. I read a different post where it was talking about this and it may not be hooking but the transom comming out of the water and the motor pushing the back of the boat around? I was wondering if I dulled the inside sponson edge by where it starts to curve up,if that would loosen it up a little? The post said that the sponson inside is like a turnfin. Seeing if anyone has any suggestions. Thanks