- Joined
- May 10, 2007
- Messages
- 309
Anybody out there run a calcraft mono. If so please send me pictures from the side, back & bottom. Thanks
What's the length on that one Doc ?
I think it is the 44 inWhat's the length on that one Doc ?
How does it drive Doc ??
Will it carve lane one turns on the start with no throttle blip ?? and stay on the pins ??
That's what I liked so much about ole Leroy Huss's Husselcraft's ... they were SO predictable on a flying start...WFO on the start..and slam it into the turn...never lifting the go button...
They would carve such a great turn that I had my dual rate and end points set where I could crank the wheel full right at pin 1 and the boat would come out perfect at pin 3...
Husselcrafts were really predictable when you couldn't even see the boat when there was a wall of water being thrown up at the start .
I still have my .90 ( F mono ) that I won D7 high points with... will probably never part with that boat...
but,, I have been on the prowl for a .20 boat.. 40" is a little long for a .20 I would think??
No it does not corner as you describedHow does it drive Doc ??
Will it carve lane one turns on the start with no throttle blip ?? and stay on the pins ??
That's what I liked so much about ole Leroy Huss's Husselcraft's ... they were SO predictable on a flying start...WFO on the start..and slam it into the turn...never lifting the go button...
They would carve such a great turn that I had my dual rate and end points set where I could crank the wheel full right at pin 1 and the boat would come out perfect at pin 3...
Husselcrafts were really predictable when you couldn't even see the boat when there was a wall of water being thrown up at the start .
I still have my .90 ( F mono ) that I won D7 high points with... will probably never part with that boat...
but,, I have been on the prowl for a .20 boat.. 40" is a little long for a .20 I would think??
Enter your email address to join: