Buckshot's latest activity
Help Support Intlwaters:
-
Perhaps the large bearing inner race I.D. has a larger radius on one side than the other and it's in backwards? Seen that before. -
Buckshot replied to the thread K21 Deliveries.Not excessively. I think the big bearing pocket would need to be a few thou deeper to release some end play if desired, but so far I...
-
Buckshot replied to the thread Twin limit.Not in F but you can in Twin Hydro. But .80’s are all you need. 🤭
-
Buckshot replied to the thread K21 Deliveries.I ran the test engine pretty hard with the bearings that it comes with and had no issues. The rod has not been modified, and it has had...
-
Buckshot reacted to Mike Hughes's post in the thread Altamotive (Brent Byers) Wire Drives with
Like.
Wire drives should be set up with a little amount of bend as possible. No hard corners. The bend should be over a large area in small... -
Zipp Kits sells .150 X.187 flex shafts, website says they are soldered, and USA made. I run them in my JAE 12 since 2016 w/o any...
-
I believe I've caught up with everyone who has ordered a K21. The last four engines ordered are either in the amil or ready to mail...
-
Buckshot replied to the thread K21 Deliveries.Yes
