Looking for a presure fitting for a 45 outboard pipe thanks
Help Support IntlWaters by donating using the link above.
Looking for pressure fittings
Posted 16 April 2018 - 10:29 AM
You can always use an exit water cooling fitting that you use for an inboard non rigger that exits out the side
Posted 16 April 2018 - 12:22 PM
For a outboard 45 pipe
What exactly are you looking for?
John is showing a "Butt Load" of the Tetra 90* fittings in stock.
And I'm sure he has some of the Mac's thin wall pressure fittings
Posted 16 April 2018 - 01:17 PM
I called he told me he had nothing for the outboard pipe, it has a 10- 24 thread, The tetra does not work on a O.B. pipe must have a 10-24 threading to go into the pipe
Edited by Robert Pickard, 16 April 2018 - 01:24 PM.
Posted 16 April 2018 - 02:16 PM
Personally I'd just drill and tap the pipe 10-32 and use a 10-32 fitting. Plenty of 10-32 fittings in straight and 90 degrees. Offshore electric has a good selection and decent prices.
Posted 16 April 2018 - 02:41 PM
The pipe is made already for a 10-24 all O.B. pipes come drilled and taped
Posted 16 April 2018 - 02:51 PM
If the option is between not being able to find a fitting for the thread the pipe is d/t'd for and changing it to a thread one can easily find fittings for, I was sharing the approach I'd take.
Posted 16 April 2018 - 04:08 PM
Posted 16 April 2018 - 04:15 PM
This is a J pipe where you do not have that kind of room to work, unlike a regular nitro boat, wish i could but no room