David Santistevan
Well-Known Member
- Joined
- Aug 5, 2011
- Messages
- 1,369
Anyone know where I can find the water fittings for the NR DD.46 ?
Thanks,
D
Thanks,
D
NR .46DD - Where to find water fittings
- Thread starter David Santistevan
- Start date
Help Support Intlwaters:
Jose F Cid
Well-Known Member
- Joined
- Oct 20, 2011
- Messages
- 345
McMaster Carr has them all look under barb fitting they have both standard and metric.
Jose
Jose
- Joined
- May 10, 2010
- Messages
- 3,005
What you building David? Is that an engine you won at the Nat's?
Brad
Brad
David Santistevan
Well-Known Member
- Joined
- Aug 5, 2011
- Messages
- 1,369
It's another Eagle B hydro. It's been in the works for a couple of years, just finishing it.
D
D
- Joined
- Sep 12, 2008
- Messages
- 564
I asked Glenn the same question last week as I was looking for some right angle fittings and he told me that most folks drill and tap them to a more standard and readily available size like 10/32.
David Santistevan
Well-Known Member
- Joined
- Aug 5, 2011
- Messages
- 1,369
Greg, I would love to even find some that are standard sizes. Does anyone even know what size the motor is currently setup for? It looks like a 4mm but not sure.
D
D
Andy Brown
Well-Known Member
- Joined
- Feb 8, 2003
- Messages
- 2,657
K&B still makes their 10-32 water fitting that curve about 60 degrees. They are great for 21- 45 engine because they are not too bulky and because they are curved they flow better than 90* fittings.
Call Gary @ G&M models 630-279-2451 He normally has them in stock as well as many other hard to find K&B parts.
Call Gary @ G&M models 630-279-2451 He normally has them in stock as well as many other hard to find K&B parts.
- Joined
- Sep 12, 2008
- Messages
- 564
Been a long time since I've needed any and I got mine from the rc boat company but when I checked their web page they no longer have the ones that I ordered so long ago, I would check where Andy suggests and see what you can find there.
