Seaducer 31 setup/help

Intlwaters

Help Support Intlwaters:

Mike lasorsa

Well-Known Member
Joined
Jul 19, 2022
Messages
156
Picked up a 31 inch older seaducer with a k&b. What’s a good prop and strut height and angle to start with? Looks like this rudder is older style as it has one bolt and no sheer screw. Looks like a auto bailer was added at some point. Should I re epoxy the shaft? Not sure how it will hold up with some heat to it. And lastly any idea of a year range this was produced?
 

Attachments

  • 184ED14F-71DE-4DF1-A20D-1CD9270AB3DF.jpeg
    184ED14F-71DE-4DF1-A20D-1CD9270AB3DF.jpeg
    1.7 MB · Views: 0
  • 0F3062B9-C836-4851-81CB-6ECECB3EE434.jpeg
    0F3062B9-C836-4851-81CB-6ECECB3EE434.jpeg
    1.6 MB · Views: 0
  • E5B389A7-2176-4A41-8306-5C351C2BC190.jpeg
    E5B389A7-2176-4A41-8306-5C351C2BC190.jpeg
    1.3 MB · Views: 0
Joined
Oct 2, 2005
Messages
7,219
Mike, your boat actually looks like the 29" Seaducer, due to it's sub-surface drive. Some actually prefer this hull over the newer 31" which is surface drive.
With the limited power of the K&B & with it being sub-surface, I would start with an X437/3
 

Mike lasorsa

Well-Known Member
Joined
Jul 19, 2022
Messages
156
Mike, your boat actually looks like the 29" Seaducer, due to it's sub-surface drive. Some actually prefer this hull over the newer 31" which is surface drive.
With the limited power of the K&B & with it being sub-surface, I would start with an X437/3
Your correct 29 just looked. Does the strut height/angle seem to be in a ok spot?
 

john v

Well-Known Member
Supporting Member
Joined
Oct 10, 2007
Messages
832
surface drive with a kb, 437/3, i would check with jerry from seaducer if because its a sub surface if it runs a different prop, i never ran a mono with a sub surface prop
 
Top