Scale Thunder Boat set up

Intlwaters

Help Support Intlwaters:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

Greg Rowe

Well-Known Member
Supporting Member
Joined
Feb 19, 2013
Messages
736
This is a ZipKit Thunderboat
My question is the turn fin
If my boat appears to be flighty, would this mean the turn fin is angled to far forward.
What would be run of thumb setup to start with?
The boat ran fine until I sharpened the leading edge,after that the boat always appeared to be loose and would blow over.
I have purchased a new Zipkit turn fin. What's the starting point
Thanks
Greg
 
Greg - there is a lot of great set-up information in the manuals or on the zippkits website. I've always had good luck with the stock settings and then adjusting to fit the driver. Which hull are you running? is the strut set at the stock setting?
 
Back
Top