• If you have bought, sold or gained information from our Classifieds, please donate to Int'l Waters and give back.

    You can become a Supporting Member which comes with a decal or just click here to donate.

Picco 80 with venturi and exhaust throttle.

Intlwaters

Help Support Intlwaters:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

MarkDanielsSr

Well-Known Member
Supporting Member
Joined
Feb 10, 2009
Messages
683
A Picco 80, has a venturi and a Gardner XXL exhaust throttle on an adapter for this motor. Bearings are good, motor is ready to race. Should be cleaned as it has been sitting. Overall a solid motor with no scarring or cuts. I will ship in a box inside a USPS flat rate padded envelope in the CONUS, international shipping is higher. Asking $215.00 plus shipping, open to trades, partial trades, and offers. Can always use parts, hardware, etc. What do you have ? Motor is listed on multiple sites.
 

Attachments

  • DSC00380.JPG
    DSC00380.JPG
    1.9 MB · Views: 126
  • DSC00383.JPG
    DSC00383.JPG
    1.8 MB · Views: 122
  • DSC00384.JPG
    DSC00384.JPG
    2.4 MB · Views: 118
  • DSC00385.JPG
    DSC00385.JPG
    2.2 MB · Views: 120
  • DSC00386.JPG
    DSC00386.JPG
    2 MB · Views: 126
  • DSC00387.JPG
    DSC00387.JPG
    2.1 MB · Views: 119
  • DSC00388.JPG
    DSC00388.JPG
    1.9 MB · Views: 111
  • DSC00389.JPG
    DSC00389.JPG
    2.2 MB · Views: 105
  • DSC00390.JPG
    DSC00390.JPG
    2.2 MB · Views: 108
Hey Bradley, Are you getting into my shop at night way down here on the Gulf Coast? I looked in the exhaust port, the top of the piston, and from the bottom of the rear housing at TDC, and these old eyes saw no problems and also felt no issue. Today at your request, I took it all the way down, sure is a hot spot on the piston, not felt with finger but evident to eyes and when rubbed with a fine metal point. Looked and felt entire cylinder and have not found a corresponding spot. Even went as far as sliding finger with pantyhose in and on it and could not find a groove or hot spot. I took lots of pictures. I even tried installing piston backwards and other than a little tighter approaching TDC, no issue. I have reassembled the motor and it is still for sale even if I look like a newbie. Here are your pictures sir. Please use your insight to send me a set of lottery numbers, lol. I will never take a shortcut again even though it seems I first said that 40 years ago
. DSC00420.JPGDSC00421.JPGDSC00422.JPGDSC00423.JPGDSC00424.JPGDSC00425.JPGDSC00426.JPGDSC00427.JPGDSC00428.JPGDSC00429.JPGStay safe my friend.
 
Back
Top