Picco 67 EXR

[daveberari]

Need to find “wrist pin retainers” for 67 EXR Need help for a source!

 

[brad nichols]

I would try Andy Brown at CMDI

Brad

 

[daveberari]

Thanks

 

[daveberari]

Thanks

Does anyone have new contact email/phone for Andy Brown

 

[Danny King]

They are the same as Cmb 67/80
Stu Barr
(317) 462-9978

 

[daveberari]

They are the same as Cmb 67/80
Stu Barr
(317) 462-9978

Thanks will give him a call cuz also need a CMB 67 header

 

[TomMason]

do you have the part number for the picco 67 exr. I may have some, not sure would have to look.

 

[daveberari]

do you have the part number for the picco 67 exr. I may have some, not sure would have to look.

Sorry parts list paper is long after 20 yrs !

 

[Joe Wiebelhaus]

Thanks will give him a call cuz also need a CMB 67 header

Dave,
Picco 67 EXR c clip wire dia .017, CMB 67/80 MAC is .019
The CMB c-clip will fit in the hole, but wont seat in the groove.
Call me or e-mail

 

[daveberari]

Dave,
Picco 67 EXR c clip wire dia .017, CMB 67/80 MAC is .019
The CMB c-clip will fit in the hole, but wont seat in the groove.
Call me or e-mail

I will see you at the mtg Thanks for the info also got some scale questions

 

[daveberari]

I will see you at the mtg Thanks for the info also got some scale questions

Just found out I can’t make mtg will call or email

 

[Joe Wiebelhaus]

Dave,
Picco 67 EXR c clip wire dia .017, CMB 67/80 MAC is .019
The CMB c-clip will fit in the hole, but wont seat in the groove.
Call me or e-mail

Correction
I just looked at my Picco 67 parts, the wire O.D. is .019
my bad
So the CMB 67 c-clip will work.

 

[JoachimRuess]

The problem is:
the C-clip from CMB will work but can‘t be removed!
The original picco clip is a G-clip!

 

[TomMason]

did you ever find some wrist pin clips?

 

[Joe Wiebelhaus]

I have originals, but we normally cut the tang off on the exhaust side