Picco .45 Blackhead Threads

[K F Wheeler]

O Kay...
Here's one for the real motor heads...
Since this motor hasn't been made for a while... Can someone tell me what the threads are for the .45
Picco Blackhead on the end for the cable collet? Think it's 1/4-28? And maybe the diameter of the recess where the cable collet fits into???
Have run the cable collet where it was flat without the little nipple to fit inside of the flywheel. But didn't like it. Just had a
sneeky feeling that was a "no-no'...
Thanks in advance!
Ken

 

[Mike Hughes]

It depends. I have seen those motors with both the 7mm and 8mm crank. If it is 7mm then its 1/4 28 thread. 8mm is 8mm.
Mike

 

[derek owen]

IN Around a week I should have some 7mm cranks and a 8mm crank just for ref here in the uk ...

 

[K F Wheeler]

Thanks, Mike!!
Ken

 

[AgafonovRoman]

IN Around a week I should have some 7mm cranks and a 8mm crank just for ref here in the uk ...

Don't forget about us, Derek. )))

 

[derek owen]

Don't forget about us, Derek. )))

soon as i have i will post up here on int w with dimensions thanks all

 

[K F Wheeler]

Thanks, Mike!!
Ken

 

[K F Wheeler]

Derek,
did you ever get those Picco cranks in for the .45's?
I'd be interested in one...
Ken