- Joined
- Oct 24, 2002
- Messages
- 4,510
Well I bought a new novirossi 21 DD for my mono. any tips out there for this setup?
Ran a tank of fuel thru it to loosen it up some, ran it to temps of 110 to 150 so it was bit rich. It will start without the wrench now. Motor sounded good and responded well to throttle, will give it a go on the lake soon.
I have the cmb pipe on there set about 8 inches, have a cooper pipe too.
i had to switch the flywheel from the mac 21 to the rossi cause the motor sits so low in this boat the rossi flywheel hit the hull bottom.
SO now I need a flywheel and cone for the Mac21 mac or cmb will work, anyone have one???
Ran a tank of fuel thru it to loosen it up some, ran it to temps of 110 to 150 so it was bit rich. It will start without the wrench now. Motor sounded good and responded well to throttle, will give it a go on the lake soon.
I have the cmb pipe on there set about 8 inches, have a cooper pipe too.
i had to switch the flywheel from the mac 21 to the rossi cause the motor sits so low in this boat the rossi flywheel hit the hull bottom.
SO now I need a flywheel and cone for the Mac21 mac or cmb will work, anyone have one???