New FE Scale layout

[Stephan Peterson]

 

[ACTION JACKSON]

Nice setup . Are you enclosing your motor & batteries from water

 

[longballlumber]

Looks good Steve! So easy even a Nitro guy and do it! LOL

 

[Stephan Peterson]

Yes everything will be enclosed. I still have to install the bulkhead around were the stuffing box comes into boat. I will post a picture when done. Side pockets for batteries were glued in before I glued the boat together

 

[Stephan Peterson]

Bulkheads installed fully enclosed electronics

 

[ACTION JACKSON]

Like the lid. Hope I can get mine to fit like that. Is there enough room to pull batteries out without removing speed control.

 

[Stephan Peterson]

Yes their is room. I am using 9500 Mah CNHL batteries.

 

[Stephan Peterson]

Getting closer. will reinstall all electrics tomorrow.

 

[Mike Hughes]

Looking good

 

[FloridaScaleBoater]

Beautiful work Steve, as always!

 

[Stephan Peterson]

Just need details on cowl. then ready to test.

 

[ACTION JACKSON]

Are your electronics on a tray or did you bolt motor & controller through hull.

 

[Stephan Peterson]

Controller is on a tray and held down with velcro. Motor mount is attached from under boat. Batteries on tray and held down with velcro.