Henrikjensen
Member
- Joined
- Oct 16, 2022
- Messages
- 17
My first attempt at making mold and making a fiberglass boat , mold will be made from a 150% sized thingiverse jetboat , ist about 75 cm without jetdrive .
Just closed of in and outlet with styrene sheet in the 3d printed hull today , tommorrow it will get filler and sandet , then split into top and bottom piece for mold making .
First i bought a 40 mm jetdrive and upgradet it with alu impeller , then descidet it was to small , the i printed a 54mm jetdrive , but its giant , yesterday i picked up 2 older style graupner jet drive 5 still brand new in box from what i found out 700-3000 watt recommendet , and it has a 49 mm impeller .
Just closed of in and outlet with styrene sheet in the 3d printed hull today , tommorrow it will get filler and sandet , then split into top and bottom piece for mold making .
First i bought a 40 mm jetdrive and upgradet it with alu impeller , then descidet it was to small , the i printed a 54mm jetdrive , but its giant , yesterday i picked up 2 older style graupner jet drive 5 still brand new in box from what i found out 700-3000 watt recommendet , and it has a 49 mm impeller .
Attachments
-
20221005_200217.jpg1.9 MB · Views: 0
-
20221022_175040.jpg2.8 MB · Views: 0
-
20221022_175048.jpg2.7 MB · Views: 0
-
20221022_175126.jpg3.2 MB · Views: 0
-
20221103_141609.jpg2.8 MB · Views: 0
-
20221103_141616.jpg2.9 MB · Views: 0
-
20221103_141621.jpg2.9 MB · Views: 0
-
20221103_141642.jpg3 MB · Views: 0