Futaba 3PM/3PMR antenna support

Intlwaters

Help Support Intlwaters:

Lee Whiteley

Well-Known Member
Joined
Apr 2, 2010
Messages
162
I sure can use this device. Now if I could only get stuff to stick to table. Will try again with this thingy!!

Thanks,

Lee
 

Grimracer

Well-Known Member
Joined
Dec 27, 2001
Messages
8,867
Lee,

Wash the plate with water
Clean the plate with denatured alcohol
apply the glue in a wind row fashion (the entire plate) wait for it to dry
re-apply glue (wind row) at 90 deg to the first (wait to dry)
Print
 

longballlumber

Well-Known Member
Joined
Apr 17, 2003
Messages
1,400
Lots of variables here; Assuming you using PLA material and the printer has a heated bed:

I have good success using blue painters tape on the on the print bed also
 
Top