Electric start

Intlwaters

Help Support Intlwaters:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

ACTION JACKSON

Well-Known Member
Supporting Member
Joined
May 10, 2007
Messages
305
Does anyone make a electric starter for these gas motors. If not what size of electric motor should be used along with gear size. I would want to use a toothed belt to keep things quiet. Hope you can steer me n a good direction. Also what tapper is on the pully side of crank. I run a bzm 29.5, are the ranks the same as the zenoa. Thanks for any help you can give. I'm talking about push button start.
 
Last edited:
I use Daniel Place‘s starter pulley which mounts to the flywheel side. Just take off the pull starter and remove the nut and screw on the pulley. I also use his starter belt and I turn it over with a Sullivan Dynatron connected to 24 volts. No problems turning over any size gas motor. Are you talking about this or something else like some sort of on board starter?
 
Back
Top