billet headers for CMB /Pico .45

Intlwaters

Help Support Intlwaters:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
It is the small ID for a MAC .45 not what I am looking for.

I know...and that's the issue. I'm going to see if a can get some made with the correct OD

and a 2°-3° taper machined into the ID, with the minor diameter equal to cleaned up diameter

in case outlet. In looking at my Hobbs headers, the tube appears TIG'd on.
 
I know...and that's the issue. I'm going to see if a can get some made with the correct OD

and a 2°-3° taper machined into the ID, with the minor diameter equal to cleaned up diameter

in case outlet. In looking at my Hobbs headers, the tube appears TIG'd on.
Bin down this road.
That is why I am asking if any one else makes a billet header for this eng.
 
Bin down this road.
That is why I am asking if any one else makes a billet header for this eng.

Not that I'm aware of..... the NR header is the size you want, but don't think it's billet,

and NR is defunct. The NR is a good header, but I had to tweak a bit of angle out of it

for a rigger.
 
The MAC .45 had a small ex port and casting for the ex port in the case.
The header is made for this.
The AA header is a copy of the MAC header.
 
Can I get one for a CMB 45 evo that has a 5* angle ? The pipe needs to go under the cowl.
 
Back
Top