BACKLASH GEN3 NITRO ????

Intlwaters

Help Support Intlwaters:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
I dont race, only wanted to try it for a project , I'm sure the boat would get along well with a 90 or 101
 
might be a good one...the motor weight difference would need to be considered and due to the fact that the center rails are cut out a lot you might have to remake them . i think you would have to move the motor to get the right balance as well.
 
Whiplash has been done with a cmb cube and was very quick from reports ,,there was also a whiplash with twin cmb 80s ,,
Don't remember where I saw them.
Your Backlash with twin 90s would be ok..
 
I ran a 1" in a Gen II whiplash with reasonable results. It ran consistently in the 72-74mph range. It did have a little trouble trying to get on plane and needed a long pipe setting to run. The problem I had was finding enough room for 30oz of fuel. I was just using the gas tank i had in there previously from the gas motor.
P1040692.JPGP1040687.JPGP1040737.JPG
I have pics of the twin 80 too.
2nvgw8w.jpg14ie69u.jpg
 
Back
Top