Search results

I have some with me.

Will do

Mike, I would like two sets. Al Hobbs 2402 Old US Highway 91 Cascade, MT 59421 I am attending the Spring Nats in Georgiaand will be back home the last week of April. Al

Reviewing the post, I originally said that the needle bearings would be sold at $28.00 for 100 pieces. That was a typo, the price is $38.00 for 100 pieces. I'm sorry for the mistake.

Thanks for posting this Terry. I toured the K&B factory after they moved to Arizona. John Brodbeck was a friend to all model boaters.

Going into thew mail to you on Tuesday. Thank you for the order.

If it is kept in a cool, dry and dark place, it will last a few years. But, before you use it, pour it through a fine filter to remove any coagulated oil.

Send me your mailing address and I'll get them coming to youu. Al Hobbs

I hope to be in Calgary. See you there.

The K21 small bearing is recessed 0.040". If you only press the bearing in even with the crankcase, the bearing is not fully seated.

6002 bearings should arrive in July.

I used Endura for several years. When it cures it is hard to even make a scratch in iit. But, it is scary stuff, so you have to know what you are doing. I have a spray booth with an exhaust fan. I used a full mask/hood with air supply from outside, covered my entire body and wore gloves when...

Send me your mailing address.

One and one quarter pounds. I was surprised.

There are various sizes of needle bearings produced. I stock bearings to support the engines I have produced and the engines I intend to produce. If you want, I can send you a small package of needle bearings and you can try them. If they do not fit correctly, return them to me.

Measure the needle in your engine. If they are 1.5mm diameter by 7.8mm long, mine will fit.

Measure your needles. If they are 1.5mm diameter by 7.8mm, the ones I have will fit.

CMB, Kalistratov and MAC 67, 80, and 90 engines use needle bearings at the crankpin. It is not difficult to replace them. I count out exactly how many needles are to be installed. I either use Rislone oil or cable grease to hold the needles in place while I install them. This helps to hold...

Needle Bearings wear just as any other bearing. Jim Allen explained that the needles wear along each end. After a while the surfaces become concave, with an oval wear pattern along the outer 1/3 of each needle end. This means the connecting rod can tilt more to both sides on the crank pin...

Marvel Mystery Oil and ATF have similar viscosity. ATF is quite thin as far as lubricants are concerned. It will find its way into the smallest corners of a transmission and will find its way into the tightest spots in your engine. But, because it is so thin, it will also leak out of your...