Search results

Hello, when running a remote needle do you find that when you get the needle dialed in, that the numbers on the flow meter are richer, or lower than when not using the remote needle? When just going through the carb needle the numbers are around 17 higher than when going through the remote...

Hello, Our club has got a new retrieve boat and it needs to be set up. I am seeing if anybody has pics of their retrieve boat or suggestions. I have read about racks but have not seen them. Wondering how to make a rack that works for all hull types. So basically looking for pics and ideas. Thanks

Hello, I am trying to get in touch with Dan Hermes. I know he is a member here but does not seem to be active here. If possible could someone message me with contact info? Thanks

Hello,I am running a Woodstuff hull,electric 4 cell. It ran fine before so I think I need to undo some work I did to the hull. I wetsanded with a block the hull bottom. It was pretty thick with clearcoat so I was able to get nice sharp edges, The problem I have now is when I set it into the turn...

Hello, I want to change my pto bearings and I am wondering how you guys hold the shaft from turning when removing the nut and also which direction does the nut come off? Thanks

Looking for a used Lynx hull in good shape.

I was wondering what steering servo you guys are using? Mainly how much torque. I am running a visioncraft with a os. I am using the Futaba S-3305 124oz torque and it has been working for me but I was wondering if most people are using a servo with more torque than that.

I have a stock sleeve that is good but I want to run a new piston. I have a RG piston/sleeve that the sleeve has not been modified yet. I was wondering if I can run the RG piston in the stock sleeve? Thanks

Hello, Last season we ran technology 55% fuel and had no problems. This season we were in a bulk order for red max fuels and we got 60% . I am running the last gallon of technology 55 and have no problems. My dads boat with the 60% red max wont go more than 4 or 5 laps and quits. Motor is...

Hello, I was wondering what the main goal is when adjusting the mixture screw? Is it for mainly throttle responce, or for idling? Does it have any affect on full throttle running? I know how to adjust the needle valve but not sure what the goal is with the mixture screw. The manual is not very...

Hello, I was wondering if you guys are cutting the skeg on the os lower unit, I am talking about narrowing it. I have read something about this a while ago but cant find it. Also if you are cutting it do you cut it from the back,prop side or the front side and how much do you narrow it to? Thanks.

Hello, I was wondering if you can this west system epoxy and if so with what? I am blueprinting the bottom of a VS-1 and I need to reseal it but I dont want to put a thick layer of epoxy on, I want to keep my sharp edges. Thanks for any tips.

Hello, I have a couple of stock OS outboards that I am looking to get worked on for better performance. Who out there does this kind of work and if you know how to get a hold of them. Thanks Jack