Search results

I would have won B Hydro if i would have entered of course but that's a no brainer Ok ok enough of my bad jokes lol. Here is some footage i put together with my drone. I had a great time just hanging out and helping where i was needed in the pits or on the stand etc.

I haven't had the time to even start any of my boats this year. But i made sure i cleared my work schedule as i wasn't going to miss this race and it did not disappoint! As always job well done Mike! I always enjoy this race if i race in it or not.

Its yours Mark!

$80 OBO? Not sure what these go for used.

Yes it is. Sorry about that.

I have a .21 SPP Carbon pipe for sale. Used it a few times for testing. $100 OBO shipped to the lower 48. I have some other items for sale i will be putting up soon.

What props do you find work best with these JAE 21GT built right out of the box Martin? I see that you like the Bouchie pipe with your .21DD. I will have to give one a try! All i have ran on mine is a SPP carbon and the Novarossi 50040 pipe so far.

Mark my thoughts and prayers are with you, your daughter and family! On to some good news. My 1917 prop you did for me last year is an awesome heat race prop for this boat. Mine is larger in diameter etc then some but my engine the Novarossi .21DD is not stock either of course... if it was it...

That's my old JAE G2. And it runs perfectly straight when i am up to speed i have it set for whatever that is depending on prop etc. I did back way off after the 2nd lap until i got back into it on the last lap i made.. But slowing down would cause it to go to the left with the slower speeds if...

I wont be missing my clubs race which is by far my favorite race of the year at my favorite place! Work will be held off for this one! B-Hydro and Sport 20 as far as i know so far. Id like to run a sport 40 "hint hint Mike Starret" If ya got one to spare that is. I will try not to take a...

Wish i could have made it. Always a good time at Madison with you all! I had to work Saturday instead.....

I always use a GPS and some common sense. If its not VERY repeatable you most likely didn't obtain that speed. But on a nice clear day where u can get a good signal and going straight and able to hold the speed for a few seconds with GPS u will get an accurate speed reading. I use my GPS for...

O'rly... This was the last time we raced B hydro against each other last year... which was my 1st b hydro id ever had and i think the 2nd or 3rd boat race i ever went to or entered?? I'm a newb to boats! BTW my rigger is 10mph or so faster now. Gotta give it right back to you if you ask for it...

IF my parts get here ill be there.. But its not looking good...

Not sure ill be able to make this race unfortunately Karla. So take me out for now.

Put me in for B hydro and sport 20 2.4radio

For engines with silicone filled crankshafts such as the 21DD and the 46DD you need to make sure you use something that wont eat into the silicone over time for an after run oil. I use Synthetic ATF.... Yes thats Synthetic automatic transmission fluid... Nothing real fancy it just works. I've...

IMHO it applies to most all taper piston fit liner engines. Basically engines without a piston ring

If u want to or ever decide to part out.. ill take dibs on motor or pipe if its a SPP carbon pipe.

I put this video up on my AB Mods Facebook page today as i was going through some old youtube videos. Thought i would share it with you all here at IW and hope some of you enjoy it! This is the same dyno i use to test marine engines with. I have learned a lot from this thing over the years. Its...