Search results

Mongoose wanted. Dist 4

Here's something I think Andy put together.

Motor mounts extra. All running gear.(w/a 1662) I gota keep the c&d 45-60 fin. Front spon cnt to cnt 7"

Wanted ABC 2717-19 uncut casting.

Sold

Found the rest of the parts. Header goes to frank. Ops 90 big block mounts. (4 3/16 --4 1/4 tub) uses cmb alpha isolators. Ops remote neede. (90-- 1.2 ) carb, and an adapter I cut to repair that cracked pinch collar and a 90 Ops carb machined to fit.. (aline drill and tap require.) Gota half...

Two sets of needels, 3 needle bng rods.(2still in pkg.) One button in pkg. And a 6 pack of case gaskets. In pkg. Bother engs are machined housings fr. And back. I'm asking 315.00 if I ship.

Pressing right side inside sheet.(left side was done earlier)

I'm going to take a food order , race day, early. Simple ham turkey @ Swiss sub. So far I'm thinking a 4 ' sub.( 5 people per foot) post if your interested. Will help me prepare the caterer for what we need. 3 to 4 $ donation per person

Going thru one of the boats I Wana run. During a balance charge total voltage went to 8v. ( 2s pack) Stopped there. And then went thru another storage charge. To 75% .. cell 1- 3.312v #2 at 3.18v .. Any thoughts?

4 cmb needles. One is SLIGHTLY used. One ops. It's off a 1.2 .. 25.00 ea. Shipped

Looking for a recommendation on tank size for a heat boat running rich of good enough. 18oz in it now

4 cmb valves, 3 never used. 1 ops valve. ( ops 1.2)

Need seals . Aeromarine if there out there. Other recommendations welcome

Asking 200.00 for both transmitters and all receivers

Any good somewhat bigger carbs for the 80 hr. Must have low speed needel

Looking for Prather mufflers. Both sizes

An e hydro.

No speed secret here, ya got some? BUT working on one for this weekend. Thought of something that might put a little more safety in a random box. After you make your pushrod run to the switch 1/16 hole for a 1/6 rod. ect. Put a little bend in the rod at the bulkhead hole. Keeps it either on or off

My question is will a properly set up 1/8 wire drive handle a strong 67 hydro pounding the water with a big prop?