Search results

Try different servos and Rx pack, one may be bad and under running load it’s causing problems.. you mentioned both engine and steering issues, random issues with both, could be a sign of a bad piece of electronics. Especially if it sat, maybe corrosion set in and a servo is drawing more load...

Darn can’t make it, have the kids that weekend.

It’s the first electric model with TD mod ( 4 step ), dihedral bottoms, new turn fin mounting for new fin design, Exact fit pieces for less sanding.

Yes, shorter and narrower.

Here’s mine! R4 vs 33FE size comparison

1 slow mill lap, 8 laps for the race, and I believe I did one extra this heat. So about ten laps and it comes in the 20%’s remaining capacity.

Running an ABC 1914 -17/45

Here is mine: TP-4060-1650kv Seal 200A esc Gens Ace 6s-5000mah lipo

I’ve ran both layouts, motor front and rear, and prefer the front layout for a few reasons. I race both 4S and 6s versions, but don’t use a huge amount of capacity in the battery, it’s not needed. It might drag ass with 10k mah in the rear, but I can usually finish the race and complete an extra...

Here is the best layout for the 33FE we have found. Performs better with battery in the rear.

I think D3 is working on a 3 series race for FE and Nitro specifically.

The pull saw I discovered by accident, I had one to cut door trim when installing laminate / hardwood flooring. Then realized it easily trimmed large sheet overhangs, without even scratching the wood surface. Just don’t get the harbor freight one, it does scratch the wood.

If you are going to build more in the future, these two tools save huge amounts of time trimming sheeting.

I like a directional connector and use the green castles, or bullets work.

The issue is the battery connectors (xt90’s) rated at 90A on a setup that can pull over 200A peak. Properly size motor connectors as well to reduce resistance. I successfully race the TP 4092 -1650kv, seal 200A, on 6S, with ABC H-7 or 1914. Does low 70’s mph and only requires a single 6S...

Hey Brandon, What I’ve learned from my social media insights is, people are attracted to weird stuff. Top views: Crashes, Fast/SAW speed runs, RTR boats, and gas boats. I can post beautiful scratch built boats / great racing still shots, but it tanks in interactions / views. My most viewed...

Sent you PM.

I used the cheaper heat transfer paste and the top plate holds the cooler in place.

Here are mine I converted, added a 3D printed top plate.

Stay tuned ;)