Search results

OK thanks

Will check it out thank you much!

Is it a simple set up or fairly complicated?

That would be a plus is it a simple set up and easy to use?

Looking for some radio receiver recommendations I will be running a deep V with twin outboards nothing fancy no racing just for fun two channels at least maybe three just steering and throttle for now maybe trim tabs in the future! Thanks in advance!

No Jon I am in the Milwaukee Wisconsin area!

Thank you I will look them up do you know if there will be hazmat charges to go along with the order?

Yes sir twins and just for fun,and would I see a difference in performance in the higher nitro content? How high of a nitro content is safe to go with on a stock engine ?

Thank you and any suggestions and where to purchase that combination?

Looking for suggestions on brand and nitro versus oil percentages to run on an 11cc K & B outboard ?? I will be running a pair of them on a deep V if that makes a difference ! Thanks in advance !

I like the concept but I think I’m going to keep it simple for now straight up and down and close together and with the tiebar like shown in the picture which I think will give me a good starting point !!

That’s awesome , i’ve never ran anything with twin outboards on it so it will be a lot of trial and error .I have a buddy running the same boat and he has his spaced quite a bit apart from each other so I think I will start with mine as close together as possible and work from there. It will...

Yes you are correct just for fun and is there a good spacing you would recommend between the two units,would they be better off closer together or farther apart ? Thank you for your feedback !

Would it have the same affect without counterrotating props? 

 That’s a good idea I did not even think of that issue and how did you choose which side to cut off?  I guess maybe I will have to pick up a spare lower unit and test it out !

 Yeah OK I get it and I was told it would be  next to impossible to get the K&B outboards to run in counterrotation .  Would like to see that in action. 

 As close together as you can get the props I get,but the degree of the  outboards does not make any sense to me?  Because it would be impossible to steer !  Please elaborate .

 Yes they are mounted  independently and  pivot separately from each other . I think I will try single 1/5 scale servo to start out with .

 That’s a sweet set up how fast can the electric motors get it going?   Do you think I can get away with just using one  1/4 or fifth scale servo for steering or would it be easier to set it up with two seeing as how there will be more than enough room inside the boat ?