Search results

The starter for the 26 , 29 will fit same bolt pattern

connect both black and red to sane to make a pr, this esc is a dual board unit and has to have input from same source. output wires also connect in pairs one on top of each other to make 3 wire sets. connect to motor as usual. if you do not have a programmer get one from one of the online...

Looks like someone got a great parts lot.

you might be better using a mix of ply and cloth even a hard foam nose filled shape to get the lines you need. use thin stringer to reinforce joint seems

There are also compression shut off valve types wrench nuts like on a collet also change out hard tank li e to a flex one home depot will have what you need . Turn water off at main open sink tap to remove e pressure flush toilet either cut pipe back of valve or un solder remove tank line ...

Drives rudders and standoff hardware

Second that . Ptw I am the person Steve is talking about , in his no deliver issue. Don't know how many excuses I went threw over the 3 years waiting on the parts from lost address to moving etc . Not to mention sending stuff to others who had just ordered while I was still waiting. 100s...

Then why did you charge cc and not ship for close to 2 years yet sent out to others.

Steve you remember my order, 10 drive 10 6 in rudder sets and 10 t bars. Yet only got drives , the 10 so called free drives were to replace the rudder setups. Also remember your first mistake that cost me 300 dollars due to exchange rates when you hit a wrong key. I was being nice just...

well it seems as the leopard has not tried to change his spots in over a decade so it seems by what I am reading. those who want to deal with him do your research .

you can look a gas buggy pipes and mod the header ro work for an outboard.

Yes can run f hydro in impba

Well the seller stated 2000.00 or 2 k for the molds. Not 2000k. There has been a lot of r and d into the hull to come to that set of molds. Both deck and hull have gone through many changes from the start of that project and all without any cad or cnc work. All hand formed.

Those props might be for a flat bottom style boat they run in thialand etc . Long tail as seen in a bond movie ( man with the golden gun ). Also some vid of them on utube yet not much prop pics. They drag them in the vids I have seen

Thanks Steve. Metal cast purple with silver base . Sealed with endura clear. Make sure sponsors are stiff with cross brace or top deck connected or your hull will twist and it will be a nightmare to setup. Glued a cross stringer in before removing deck cross support. All serves are...

Here is a pic during build motor has under 2 gallons threw it at the moment . Breaking in with a 63mm prop.

Gray's canard does run great. Have a gas and nitro one. Still breaking in the nitro.

Nice to know these modules will work with other older radios, I use a flysky unit in my futaba 3pj and 3pjs

package off in the mail , should be at your door in 6 days . tracking info is in PM.