Search results

Hi Guys. All pipes are sold and packed ready for shipping. My town is in lockdown now due to covid so I cannot access the post office to ship. At this stage we are set to come out of lockdown on Monday and I ill ship straight away. Neil.

Hi Jeff. Yes sure I can do that. Make sure you address is on the paypal receipt. I will ship it out tomorrow with David's pipe.

Thanks David. Received along with your address. I will post it this week.

Hi Brian. No headers, the 21 which is sold was circuit, the other two pipes are SAW spec. Sorry should have mentioned this.

Done Shane. Paypal is [email protected] and send me your address. Just add $15 for postage to Hobart normal, more if you want express. Let me know.

I have three new Bouchie pipes for sale, .21,.67 and .91/101 As you can see the 67 and 91/101 pipes have been drilled for the pressure fitting. Otherwise they have never been used. Prices .21 - $200USD + shipping .67 - $300USD+ shipping .91/101 - $350 USD + shipping I take paypal, buyer pay...

Hi Guys. Is anyone in contact with Randall Thomas? Just want to ask him a few questions but cant reach him on email Thanks in advance.

Doc do you offset your strut and have the rudder on the right? Neil.

Thanks Dan, paying now.

Hi Dan. I will take this. Can you PM me total including shipping to Queensland, Australia 4066? Thanks.

Thanks Gary. The sponsons are built but I might call you anyway as I could build a second set.

Hi All. Just have some questions with setting up the 101 GT. How far back from the transom do I place the engine or do I use the 1-1.5" from the radio box bulkhead rule I read about the 91 in another forum? Also sponson width, do I go with between 22 and 24" to the outside? thank you in...

David, is that a flat bottom strut?

Prices reduced to $700 AUD or $550 USD plus postage

SOLD

Carl its a good discussion, so blow it up what evs

Hi Jim. Can I ask what prop you were using during the test that showed 20,600rpm? Did you happen to record the top speed as well? Neil.

Thanks for the info guys, this will be enough to get me going. I plan on running a cmb 101.

I received my 91/101 Truex Short kit from Joe but havent yet ordered the boom tubes. I measure the holes in the tub and sponson frames are around 10.5mm? What size booms are you guys using? Was thinking I should just open the holes and use the 1/2" solid booms? or would 3/8" be sufficient...

Excellent, Shane, enjoy.