Search results

I will take it I am going to TT for the next 2 days. Send me your address and I will send a check. In the mail on Monday.

Great video

Absolutely

Jamestown Distributors

Milled fiberglass

Billed the dam as described Fill with Mas or West system epoxy mixed with MILLED fiberglas into almost a putty fill it in. Incredible strength, like rebar. Leave a slight gap at the base of the sponson so the area can be easily re-sheeted. Aircraft Spruce has micro ballon’s and milled fiber...

Use TOTAL BOAT 2 part PENETRATING Epoxy as a sealer. It is thin and designed to penetrate the would. Then sand and then spray,I use PPG, clear. Gets rid of the grain Sand 400/600 then spray paint. The penetrating epoxy is at Jamestown

I quit using WD 40. It has a very very fine abrasive material in it. That’s why it works so well on a stuck or rusted hinge Have been using Nut Case spray as a flush then Corrosion X.

Yep, finally back in stock Just ordered 3 of them They were out of stock last week. Thanks

Yep, great system, but FUTABA USA has been out of them for many months.

Thanks

BTW, Bob’s prop work is beautiful.

I would like a 21 straight please. Send to: Gary Turner 3509 South Woodridge Road Mountain Brook Al 35223 Send me your address and how much and I will send you a check. Thanks

Total boat 2 part penetrating epoxy is the best stuff to seal wood.

I go to my automotive PPG paint store. They the best sand paper masking tape, scuffing pads, lacquer thinner, Bull spray to use first on plastic parts for pain adhesion and one of the best paint brands and ETC

Drove up to Mark Grims shop today and checked out my 2 K 21. One needed to measured and check. All was very good except Mark need to put a champhore in the rod to match the crank and set the deck clearance. Second motor we measured it and there was no endplay by feel or measurement. Mark has...

Motor and motor mount first Then put a solid shaft with the same OD as the stuffing box Tube ID Shape the needed curve in the stuffing box tube and slide it upon the solid shaft in the mounted motor. Glue and fiberglass in place. BTW be sure to leave enough room between the stuffing Botox tube...

Castro seems to help my motors that are prone to pre- ignition especially 101s

Yep, but is there less penetration between those surfaces? I have been running 14-16 % low viscosity oil 60% nitro in 101s. The bearings seem to doing very well.