I purchased this SATA regulator for my mini jet-4 but it did not do what I thought it would. I generally run my compressor tank at 100 PSI for any air tools, and then dial down the gun with an inline regulator to 30 psi and then spray away. This regulator requires a bit different procedure...
I seem to recall that someone built a rotisserie style boat stand for painting hulls. I am just about ready to start shooting color on a 1/6 scale monster and I am trying to figure out the best way to set the hull up for painting. Top and bottom will have the same color. Was actually thinking...
Can any of the scale masters tell me what version of the U-10 this is I thought it was the 1999 boat ? Thinking abut building a gas scale and the paint and graphics dont seem too intimidating for me. Also any idea on what the paint codes are for the yellow and blue. Thanks Tony J
Was going through some stored files on my HD and I found the race schedule for D-2 in 2005 ( I believe my date tags are messed up on the PC). Lots of clubs, sites, races and racers have gone the way of the DoDo in 14 years . Pretty sad actually.
Looking for some aluminum or Delrin trim washers, to be used on the bottom of a gas rigger tub for thru-bolting the sponson tubes in place. Will be using 8/32 size bolts, something around .750 OD would be perfect. Thanks Tony J
Something like this
SOLD- 2013 Aluminum Amera-Lite (by Forest River)
Located in Ontario near Detroit
6’x10’ (plus 30” wedge), Interior height is 5'6"
100% Aluminum , Mint Condition, Garage stored at all times
Custom build order low rider to fit under a 7’ garage door
Full Rectangular aluminum tubing construction...
SOLD – Ready to run less receiver SLR Missile Thunderboat built by me in 2018 Includes a lightly used Zen, Zipp pipe header and flange, Hitec 7955TG servo on steering, Savox 1251 on throttle, Speedmaster strut and rudder on a Finn one piece bracket, Gizmo motor mount. Painted with PPG Concept...
What are the rudder pins made of on Speedmaster 40/60 rudders is it drill rod or ? I dropped the pin somehow during a heat last year and need to replace it and would like a few spares. Thanks Tony J
45 Seaducer Mono – 45 Carbon/Kevlar Seaducer equipped with Hitec HS85 MG on throttle and 3rd channel (OS inflight mounted to Aeromarine needle block). Package includes the following:
Picco 8mm Blackhead with OS 40a carb and Delrin bellmouth prepped by Ron VanWagnen
Andy Brown V1 parabolic...
RCATs glo igniter lightly used with silicone bumper, new unused plug lead and charger, and a new unused Dynamite LIPO igniter and charger $100.00 shipped to lower 48. email and PP is [email protected]
20 size Aluminum motor mount components includes (8) rails that are tapped to accept the isolators, (7) of the small isolators (16) isolator cups. $40 shipped to you from Detroit early next week. My email and PP [email protected]
SOLD - Incomplete 21 mini rudder assembly includes 2 blades, standoff and pivot block, missing arm and screws, also a new 40 rudder blade. $30 shipped to you from Detroit early next week. My email and PP [email protected]