Search results

Futaba 3 channel 3pm-x 2.4 fasst w/ r603ff reciever new in the box. Item number 170741474940. Just in time for Christmas. You can type (3pm-x) and see three pictures. Only approx 2 days to go. Any questions let me know. Thanks for looking. Chris

What is the Mcmaster number for the 7.5 prop shaft bushings. Thanks chris

I am looking for a Hitec DC crystal on channel 74 and haven't found one. I was wondering if a Futaba DC crystal 74 would interchange. Thanks Chris

looking for a anderson 1450 for 7.5 ob. if you have one let me know. thanks chris

i am helping a newbie to the sport and was wondering what is the safe voltage that you can run this pack down to and still be safe. i didn't think it was the same as nmhi 4 cell packs. thanks chris

trying to find a thunder tiger prop shaft for a friend. let me know if you have one. thanks chris carboneau

the clear coat and paint is off the hull. the stripper will not take the primer-base coat off. the hull now is a even matte white. however on some of the edge's the wood is showing through. i was going to sand with 320 to rough the surface. i was planning on using hok pbc for color and ppg...

i use futaba products but a friend said the hitec receiver is better because it is dual conversion. is the futaba dual conversion? thanks chris

i am sheeting the bottom of the sponsons. this is the last sheet that is needed to complete the sponsons. should i leave a 1/8 edge on the rear similar to the dunlap 30 & villain. also i can have a shear edge like the villain s1 has or is this going to cause cornering problems with a heavier 7.5...

the previous tunnel that i have been running for the past 3 years i used 2000 sub c 6 volt packs. this is what others were using however with the size of the pack it was located outside the radio box. the weight was needed up frount so it was weight put to good use. with the new hull i am...