Search results

What is your paypal info

I would do $265 shipped.

Print your parts like Chris said, standing up. These are sliced with 4% gyroid infill. The designer says to print in vase or spiral mode. You can decide which way to go, but this is how you need to orient the parts.

Between 1/8th and 3/16 depending what props you are going to run. Also if you have a way to measure the angle, the rears should be at 1.2 to 1.5 deg on the bottom last couple inches.

Yeah, I thought those were pretty close together. I will definitely use those two methods to isolate the water block from the stack stubs. Thanks!

Thanks guys. I will give the MX6 a try. I have Arctic silver but I assume that is conductive.

I have a Castle X8s and a stumpfab water block. Can I use CPU thermal paste, or do I need something else when attaching the water cooler to the esc? Trying to get a rig together for this weekend and I have some paste left over from a computer build. I was told by a club member what to use, but I...

You can test the offset strut theory now :rolleyes: Sorry about your boat Rich.

I found some new bearings in the shop, so I only need 1 set of #3 when you get them in.

Mike, did you get the 67 bearings in? I would like to get 1 set of #3 and 2 sets of #1. Thanks.

Like this? ✂️ Contender😆

Thanks Tyler, I've been using his wire drives for a while and they work great. I want to make some square drive stub shafts to try.

Looking for some insight on what to use for stub shafts and wire drives. There are lots of choices out there. I have had issues in the past couple years with some stub shafts breaking or bending. It seems one manufacturer had too brittle of material, and another was too soft. I'm looking for...

Also, mix it thoroughly for at least a minute. I haven't used west in a while but if I remember correctly you are supposed to mix for 2 minutes.

Thanks again for the info guys. I will make a die this off season and see how it works.

Do the dimensions need to be undersized to get the correct size square? I'm guessing on these numbers.

Thanks for the info guys! Mark, Is this what you are talking about as far as taper?

Anyone have a picture of a die to square the end of flex? And how many tons of pressure does it take to square a shaft?

Thanks.

Oh yeah!