Search results

I will look, I have not ran those 17 series in a while,If I have some laying around I will send them to you.

Going to Ron, Thanks guys sold

Ron I have no O/B kit for this one it was used as an I/B

14.5 Ron You know I go big lol

I love thses motors, so much that I bought too many. selling one extra that I have. has orlic carb, and orlic cooling. about a gallon thru it, not over rev, no over heating great motor. 1st $350 which is a still.

Dick is %100 right, My fastest O/B Tunnel prop was a JG Texas cut done by Allen E. I had all of Andy Browns props in every configuration. Not saying that they would work on every boat and set-up, but that was one combo that was a Winner for me. So will they work? I think that it depends on the...

got it thanks

This is what I use along with different wheels and different polishing compounds. http://www.harborfreight.com/8-inch-bench-grinder-buffer-94327.html

Mic as I stated in my last post that I would indeed race against the boat. But If someone was to protest it I would have to side with them. Yes I have to fly half way around the world to race tunnels, but I'd rather do that then turn to gas boats. A key board racer? not by far. I love tunnels...

All have transoms.......

here is a rule in NAMBA that will dis qualify it: 3. Tunnel hulls will be of a tunnel configuration with no restriction as to size, weight, or type of construction. A hull will be classified as a tunnel if it meets the following requirements: a. The general design of the tunnel hull should...

Oh James you scared me for a minute lol

Does it say (not necessarily the transom)? if not the transom then where? inside the boat is the only option. (The rules do not define what an outboard is other than what is stated above) that's because some things are self explanatory. The bottom line is this stuff will have to be amended and...

Wow very shaky ground. My honest opinion,, and completely neutral. :mellow: And a outboard pipe does not make it an O/B it gives the look into making seem like an O/B. some ppl run car pipes, must be a car? With all due respect to John it takes away from what tunnel racing is about. I can see...

You know what, I have not seen the boat in question, No one has posted any pictures. I would say that a picture and a poll is needed just to see everyone's honest opinion. The reason being, like I stated before, I would hate to see another nitro class suffer, we O/B racers are better then that...

I remember when the first I/B motor Showed up to a race, up-side down with a belt start, mounted to a K&B lower end. I gave him an A+ for that innovation(is the creation of better or more effective products, processes, technologies, or ideas that are accepted by markets, governments, and...

Ron you are 100% right, the only problem is that this line has never been cross in this way. So things need to be re-written. When the O/B tunnel class was started. It was based off the scale tunnels. The O/B class is dead where I am at, and I have to fly to race, I just hope that this kind of...

:huh:

Ron its plain and simple, is it in or out of the boat, I would need to see a picture of it. If it is not mounted on the outside of the boat some kind of way, weather its on the sides of the hull in the front of the hull or in the rear of the hull then it is an Inboard. Clearly if it is mounted...

Also can the whole motor be removed as one unit or bolted on as one unit? Jerry I am surprised at you. http://wiki.answers.com/Q/What_is_an_outboard_engine