Futaba receiver antennas getting hot?

Intlwaters

Help Support Intlwaters:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
One more issue I see with running long antennas.

The extra length going up the tube is just folding over at speed anyhow.

The receiver antenna works considerably better and is meant to be vertically polarized. You ever watch a long antenna tube at 60 mph.

The long antenna tube is bowed over and your long antenna is not an iota taller than the shorter one was and it is laid over flat not sticking up vertical like it should be.

The tube is laid back with the end horizontal and back over or closer to the prop roost.

4-6" straight up or a 8"-12" folded back to the same 4-6" height but now it is laid flat.

The straight 4-6" one is going to give you the better range.

Noticed I haven't almost poked the ole' eye out since we got rid of those long stranded wire antennas the FM radio used to have to have.

The short antenna was all the rave of the 2.4 GHZ. Now you want to go back long for no reason whatsoever.

Decrease your range and maybe poke your eye out too. Nice.

The short vertical antenna will have better range than a long antenna when underway at speed.

9lioNys.jpg

I've always ran vertical whip on boats and rc cars that can flex.

With stage wireless mic systems we run receiver antennas at 45 degrees relative to vertical as nobody holds a mic vertical. Model aircraft don't use vertical antenna orientation.

Boats are a different animal relative to the RF as they operate on the water. Nobody I've ever seen has held a transmitter with antenna in a vertical orientation. Position varies on transmitter antenna from near vertical to near horizontal - somewhere in between. Worse orientation is transmitter antenna pointed at model, which is easy to do with aircraft.

Speculation for me would be 45 degrees on a boat would be closer to optimal to align with transmitter antenna. Being so close the water vertical as you state may be best for boats. They are a unique application for sure. Just for the record, perpendicular orientation between receiver and transmitter antenna is the worst possible condition.

Something else to think about for sure. :)
 
...........I pulled everything apart, the receiver I chose for the installation had a long antenna on it.

When I popped open the receiver I found the antenna not even attached to the board, and some green corrosion on the IC...

That receiver now resides at the bottom of the lake. That's how I fix radio problems.....

Same here Frank. I like the way you think.

I recently dumped ethernet routers new still in the box into the recycle bin. First one I installed in a pro audio rack had issues, figured it was a fluke and swapped it out, second one worked. Then sent one to California to a buddy in a rack I built up for him. He too had problems with the router. So, they all went into the recycle bin.

Radio problems, had a few over the years. Back in the early days running Kraft Brick radio's in Veco 19 powered Northwind's radio problems were common. Then I discovered Futaba. I think the Brick's just went into the trash can. But I've definitely sent a few problems to Neptune. :)
 
Ever notice how some people will go on and on to try and sell their point of view?

Ever notice how some people are so hardheaded that you have to go on and on to get them to even hear your point of view.

I already knew there was absolutely ZERO chance of you getting it but there are others reading that may have a open mind to some common sense.

You would never understand. It isn't your point of view so it is obviously wrong.
 
I've always ran vertical whip on boats and rc cars that can flex.

With stage wireless mic systems we run receiver antennas at 45 degrees relative to vertical as nobody holds a mic vertical. Model aircraft don't use vertical antenna orientation.

Boats are a different animal relative to the RF as they operate on the water. Nobody I've ever seen has held a transmitter with antenna in a vertical orientation. Position varies on transmitter antenna from near vertical to near horizontal - somewhere in between. Worse orientation is transmitter antenna pointed at model, which is easy to do with aircraft.

Speculation for me would be 45 degrees on a boat would be closer to optimal to align with transmitter antenna. Being so close the water vertical as you state may be best for boats. They are a unique application for sure. Just for the record, perpendicular orientation between receiver and transmitter antenna is the worst possible condition.

Something else to think about for sure. :)
I have posted test data on this.. a few years ago.. (its around here someplace)
 
I have posted test data on this.. a few years ago.. (its around here someplace)

If you ever come across it, I'm interested.

Here's a good explanation of things in relative terms: Does antenna orientation (vertical/horizontal) matter?

Most RF noise is known to be vertically polarized. Not suggesting that amounts to a hill of beans with RC models, just a condition worthy of mention for the discussion.

Interesting topic.
 

Latest posts

Back
Top