Carb shield

Intlwaters

Help Support Intlwaters:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
After testing Sunday I notice the sound of the motor was different as soon as I put the cowl on....I knew off rip I was suffocating the motor it has lead to this....20230822_231759.jpg
 
Yesterday's progress...I'll have to stop here for tomorrow's race...I think I'll make a mold of this just incase I lose this cowl or if someone want s one to try, I'll offer the scoop20230826_141745.jpg
 
Last edited:
Have to have an air inlet...I'll block it with window screen...the air will come in the water should stay out...im definitely going to see if that Qd breathes better...the lower sheild the way i make it came up too high but thats ok cause its better to be able to take off material than to add.20230826_141737.jpg
20230826_141814.jpg
 
The idea worked great! Just the boat came back home like thisView attachment 319356
....I lost the cowl
That sucks! The first time I started my Slingshot at the lake, I could tell I was gonna have a problem with the cowl. The engine vibration made the cowl slide back to the point where it would have blown off in the water. I had to tape it up by the lip to keep it on that day. Regardless of the strength of the magnets as far as up and down, it’s pretty easy to slide back and forth and sideways. My setup is a block with two magnets at the very back of the engine compartment at the top of the radio box bulkhead. I have a piece of carbon fiber plate glassed into the cowl where the metal discs are attached . What I did was install a 1 inch long piece of 1/8” stainless rod that I use for my pushrods directly between the magnets with some epoxy. I put a dab of paint on the end of the rod and lowered the cowl down and that marked where I need to drill a hole in the carbon fiber plate in the cowl. Now the cowls doesn’t slide back and has never come off. Sorry about your cowl.
 
Sounds like a good idea...I make my cowls now so I'm going to make another scoop and cowl...ill make a couple of them....I thought I put enough foam in there....but guess I was wrong...back to work...it does suck!!!
 
Well I started over and here's where I'm at20230831_103508.jpgNew cowl...black gel coat20230831_103646.jpgNew redesigned sleeker carb shield fits both backlash and slingshot cowls....now to apply some elbow grease and make the mold...should be popping a part by Friday stay tuned.....
 
Back
Top