• If you have bought, sold or gained information from our Classifieds, please donate to Int'l Waters and give back.

    You can become a Supporting Member which comes with a decal or just click here to donate.

Parts For Sale Wire drive setup

Intlwaters

Help Support Intlwaters:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

LibertyFrancis

Well-Known Member
Joined
Jul 9, 2021
Messages
109
Selling a New never used Brent Byers wire drive setup. I have handled the parts and played with mockup in a boat but never actually fully installed or used.
Full disclosure it is on eBay also.

Asking $170.00 shipped in the lower 48 states.

Setup includes an Speed master extended strut.
Coupler for 8mm shaft brushless motor.
Collet for alignment tool and alignment rod used for install/setup.
Collet for wire drive.
1/4" setup turned down to 3/16"
Pre-bent aluminum tube is aprox 18.5" long and has guides inside it.
Wire is around 35" long ready to be trimmed down.
Also includes a "shaft saver" and clamp for your brass tube to snug up to the aluminum tube.
Comes with 9 page install/setup instructions.

I asked that the setup be built to handle 40+k rpms and 15kW.

1638193119782.png
1638193309200.png
 
Last edited:
Precision metric wire is not readily available in the US, but Imperial is. I have to buy my precision wire material from Germany.
I had a similar experience with local machine shops.
"What is a millimeter"
Followed by spending the next 3 days converting my drawings to thousandths of an inch o_O
 
Selling a New never used Brent Byers wire drive setup. I have handled the parts and played with mockup in a boat but never actually fully installed or used.
Full disclosure it is on eBay also.

Asking $170.00 shipped in the lower 48 states.

Setup includes an Speed master extended strut.
Coupler for 8mm shaft brushless motor.
Collet for alignment tool and alignment rod used for install/setup.
Collet for wire drive.
1/4" setup turned down to 3/16"
Pre-bent aluminum tube is aprox 18.5" long and has guides inside it.
Wire is around 35" long ready to be trimmed down.
Also includes a "shaft saver" and clamp for your brass tube to snug up to the aluminum tube.
Comes with 9 page install/setup instructions.

I asked that the setup be built to handle 40+k rpms and 15kW.

View attachment 298059
View attachment 298060
I’ll take it! Just send me your Paypal address in a PM.
 
Back
Top