Recent content by Ricky Neal

Hi Al, Anyway to order one to be sent to the UK buy Paypal or bank transfer? Kind regards Ricky

Thanks All, I am in touch with Joe at Zipp Kits. thanks all the feedback

Hi All, Im well out of touch with Outrigger Hydro's but what is generally regarded as the best and most competitive at the moment? I saw from the NE-Stuff website they do the KEPS .21 and it looks great but does anyone do a kit? - I didn't want to scratch build if I could avoid it due to time...

Hi Mark, We have made a little progress, but we are having an issue getting crankshafts made - we were getting them made in Ukraine but the current situation has put a stop to that. We have had some made in Germany but we had some issues with grinding quality, we have had some made in the UK...

Thanks Daniel, that's perfect. I will take it

Hi Daniel, will you ship to England?

No, there is an RC version with a carb and the one above on an open venturi version for tethered car and hydro is use. So no throttle at all. You just start it. Dial in the needle and let it go and see how fast you can go

Hey all, I'm not dead and we are still making (SLOW) progress. We have been tweaking the open venturi induction version to improve flow where possible, have a look at the pics. We have developed the backplate cap to be able to use a venturi like this but to also be interchangeable for a carb...

Yeah, still slowly making progress. I haven't updated for a while for a few reasons (Mainly just too busy) but we had a real issue with the last lot of cases we had cast and we are getting another batch done now. I am sorry for the slow progress but I feel I definitely underestimated the...

See this link, are any of these pistons suitable for your requirements? http://hobby-miracle.com/index.php?route=product/category&path=108_55 As for piston material, it is generally regarded that you want to use RSA 444 or one of their other high silicone alloys like RSA 431 See this link...

This is such a great thing to see. When Available I will be buying at least one Just a note to anyone that enjoys this hobby, If you can afford it, buy these engines and any new engines If you want our hobby to survive. Without commercial support, it will all fade and possibly die.

If you need new oversized pistons you can get them from here, Piston for Novarossi 3.5CC КЕЕР, MITO, MEFISTO They are 0.015mm oversized and made by Anatoly Karpov, the quality is better than the originals As for chrome plating, I'm afraid I cannot make any suggestions. If the chrome is in good...

Thanks. I had to convert to metric to compare but thats 38-50 microns. Thinking about it - within reason i think its always safer to lean towards a bigger clearance. Too tight will always end in disaster

Lol, fair point - i was hoping that showing the logic may help figure out what kind of clearance may be required but i fully understand that without the specialist tools its not a whole lot of help

Hi Guys, I am by no means an expert on this but have spoken to a few that would be regarded as experts in relation to model engine design/development and manufacture and I have followed their advice when it comes to connecting rod clearance and honing as well as measurement. Everything I...